Rolling laundry basket cart – Starting with sand all edges of wood with sandpaper to remove any rough spots or splints. Place a 16 – with 35 – inch piece of MDF on the work surface on its narrow edge. Apply a strip of tassim along the bottom shorter edge of the board. Place one16 – with 22 1/2 inch MDF on work surface at its narrow edge at the bottom of the 35-inch piece to make an “L” shape. Secure the two boards with three wooden screws distributed along the edge. Apply a strip of wood glue to the bottom 16-inch edge of the last 16. With 35-inch piece of MDF. Touch the board on the other side of the “L” shape to make a “U” form.
Attach these two with three wooden screws. Set “U” piece of shape upright on the work surface. Apply a strip of wood to both side edges. Put the last 16 – with 22 1/2 inch piece on top and sideways. Attach the top piece to each side piece with three wooden screws at each end. This makes a rectangle frame. Place rectangle frame flat on work surface. Lay 22 1/2 with 36 1/2 inch piece on top. Line the corners with the rectangular frame. Screw all the way around the edge of the rectangle frame with 1 1/2-inch wooden screws distributed every 6 inches. Line a wheel of rolling laundry basket cart with a corner of the bottom of the cabinet. Mark with a pencil the location of each screw hole.
12 Photos Gallery of: Diy Rolling Laundry Basket Cart
Repeat for each corner. Drill pilot holes on each pencil brand. Dress a caster at the bottom of the cabinet with pilot holes. Screw the caster into place with the supplied hardware. Flip the cabinet again and measure along the high edge of the cabinet from the bottom and make a mark of 10 inches, 22 inches and 33 inches. Repeat on the other side of the cabinet. Place a 1-to-1 inside the cabinet along the high side. Line bound by 1-by-1 with the first mark of 10 inches and screw through 1 x 1 in the side of the cabinet. Repeat for each measurement on each page. Stand the cabinet upright. Sand and rough edges and paint or brush rolling laundry basket cart as desired.